Azbox Elite Manual do Utilizador descarregar pdf (Página 6)

The connector to access Yamon looks like this on the motherboard:

Connector on the Azbox side Connector on the USB/TTL adaptor

TX [Brown] RX

VCC DO NOT CONNECT DO NOT CONNECT

GND [Orange] GND

RX [Yellow] TX

Just as indication I give you the wire colors that I use on the Azbox side since this connector is quite

common and it is sold with the wires.

Be carefull: there is no keyed possible on the Yamon interface so you can connect you cable in the right

but also in the wrong way and this can damage your Azbox. So you should be very careful and

remember how you build your cable. On the Azbox motherboard there is a dot near the TX pin, this gives

you an indication on how to connect the cable (see later on for detailed photos).

My tip, is to use the red wired (not used) has the one for the VCC. It is just a way to remind how the

cable is build and where the RX of the cable is.

Tutorial by Pr2 for www.smartinnovations.nl and www.azboxforum.be (version 1.3) page: 6 / 35

Also available on: http://forum.azbox-enigma.eu and http://www.azboxhd.eu

1 2 3 4 5 6 7 8 9 10 11 ... 34 35

Sem comentários

Azbox Elite Manual do Utilizador Página 6